Table of Contents
Advertisement
How to Install
3 How to Install
3.1.1 How to Install Option in Frequency
Converter
3
3
Items required for installing a network option in the
frequency converter:
-
The network option
-
Network option adaptor frame for the AF-600 FP/
AF-650 GP. This frame is deeper than the standard
frame, to allow space for the network option
beneath
-
Strain relief (only for unit sizes 11 and 12)
6
PROFINET Operating Instruction
Instructions:
-
-
-
-
-
-
NOTE
Do not strip the Ethernet cable and ground it via the strain
relief-plate! The grounding of screened Ethernet cable is
done through the RJ-45 connector on the option.
NOTE
After installing the OPCPRT option, be aware of the following
parameter settings:
O-01 Control Site: [2] Controlword only or [0] Digital and ctrl.
word
O-02 Control Word Source: [3] Option A
3.1.2 Network
It is of high importance that the media chosen for Ethernet
data transmission are suitable. Usually CAT 5e and 6 cables
are recommended for industrial applications. Both types are
available as Unshielded Twisted Pair and Shielded Twisted
Pair. Generally shielded cables are recommended for use in
industrial environments and with frequency converters.
A maximum cable-length of 100m is allowed between
switches.
Optical fibres can be used for gapping longer distances and
providing galvanic isolation.
For connecting PROFINET devices both hubs and switches
can be used. It is, however, recommended always to use
suitable industrial graded Ethernet switches. GE
recommends always to use PROFINET compliant switches
Remove keypad panel from the AF-600 FP/AF-650
GP.
Remove the frame located beneath and discard it.
Push the option into place. The Ethernet
connectors must be facing upwards.
Remove both knock-outs on the network option
adaptor frame.
Push the network option adaptor frame for the
AF-600 FP/AF-650 GP into place.
Replace the keypad and attach cable
Advertisement
Table of Contents
