Table of Contents
Advertisement
3. "WATER HARDNESS" "CURRENT VALUE UNDERLINED": Press
the required level (Level 1 = soft water; Level 4 = very hard
water);
4. Press "
The machine is now reprogrammed with the new water hard-
ness setting.
15.
WATER SOFTENER FILTER
Certain models are fitted with a water softener filter (D7). If this
is not the case with your model, you are recommended to pur-
chase one from De'Longhi Customer Services. To use the filter
correctly, follow the instructions below.
15.1 Installing the filter
1. Remove the filter (D7) from the packaging;
2. Access the menu as described in section "6.1 Access the
settings menu";
3. Press "WATER FILTER";
4. "TURN DATE INDICATOR TO NEXT 2 MONTHS" (fig. 37): turn
the date disk to display the next two months of use. Press
;
37
Please note
IThe filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last a maximum of 3 weeks.
5. "RUN WATER INTO FILTER HOLE UNTIL IT COMES OUT" (fig.
38): To activate the filter, run tap water through the hole
in the filter as shown in the figure until water comes out
of the openings at the side for more than a minute. Press
;
6. Extract the tank (A17) from the appliance and fill with
water.
7. "IMMERSE FILTER TO EXPEL AIR BUBBLES" (fig. 39): Insert
the filter in the water tank and immerse it completely for
about ten seconds, sloping it and pressing it lightly to ena-
ble the air bubbles to escape. Press
" to go back to the homepage.
8. "INSERT FILTER" "IN HOUSING": Insert the filter (D7) in the
filter housing (fig. 36) and press as far as it will go. Press
9. "INSERT WATER TANK": Close the tank with the lid (A17),
then put the tank back in the machine (fig. 5);
10. "POSITION 0.5L CONTAINER" "OK TO ENABLE FILTER"
(fig. 7): Place the container under the hot water spout
(D6) and press
automatically.
The filter is now active and you can use the coffee machine.
15.2 Replacing the filter
Replace the filter (D7) when "REPLACE WATER FILTER" "PRESS
OK TO START" appears on the display: to replace immediately,
press
To replace the filter later, press
bol appears on the display to remind you that the filter needs
replacing. To replace, proceed as follows:
1. Extract the tank (A17) and exhausted filter;
38
2. Remove the new filter from the packaging;
3. Access the menu as described in section "6.1 Access the
settings menu";
4. Follow the operations described in the previous section
from point 3.
The filter is now active and you can use the coffee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
15.3 Removing the filter
If you want to use the appliance without the filter (D7), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A17) and exhausted filter;
;
18
39
;
. Delivery begins and stops
and follow the instructions from point 5.
. The
sym-
Advertisement
Table of Contents
Troubleshooting
