Table of Contents
Advertisement
DISPLAYED MESSAGE
FILL BEANS CONTAINER
GROUND TOO FINE. ADJUST
MILL
SELECT A MILDER TASTE
OR REDUCE COFFEE
QUANTITY
INSERT WATER SPOUT
POSSIBLE CAUSE
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (D7) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Too much coffee has been used.
The hot water spout (D6) is not inserted or is
inserted incorrectly
REMEDY
Fill the beans container (A4) (fig. 10).
Empty the funnel with the help of a brush (D5)
as described in section "12.8 Cleaning the pre-
ground coffee funnel".
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 13) one click clock-
wise towards "7" while the coffee mill is in
operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section "7.5 Adjusting the coffee mill"). If the
problem persists, make sure the water tank
(A17) is fully inserted.
Insert the hot water spout (D6) in the appli-
ance and deliver a little water until the flow
becomes regular.
Select a milder taste by pressing the "AROMA"
button (C1) or reduce the quantity of ground
coffee (maximum 1 measure).
Insert the water spout as far as it will go.
21
→
Advertisement
Table of Contents
Troubleshooting
