Table of Contents
Advertisement
2. Check the holes in the coffee spouts are not blocked. If nec-
essary, remove coffee deposits with a toothpick (fig. 25B).
12.8 Cleaning the pre-ground coffee funnel
Check regularly (about once a month) that the pre-ground
coffee funnel (A4) is not blocked. If necessary, remove coffee
deposits with the brush (D5) supplied.
12.9 Cleaning the infuser
The infuser (A20) must be cleaned at least once a month.
Important!
The infuser cannot be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see section
"5. Turning the appliance off");
2. Remove the water tank (A17) (fig. 3);
3. Open the infuser door (A19) (fig. 26) on the right side of
the appliance;
26
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 27);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISHWASHER
25A
25B
27
15
Clean the infuser without using washing up liquid as it could
be damaged.
6. Use the brush (D5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 28), then push the PUSH symbol fully
in until it clicks into place;
28
Please note!
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 29.
8. Once inserted, make sure the two coloured buttons have
snapped out (fig. 30);
9. Close the infuser door;
10. Put the water tank back.
12.10 Cleaning the milk container
To keep the frother efficient, clean the milk container every two
days as described below.
1. Remove the lid (E2);
2. Remove the milk spout (E5) and intake tube (E4) (fig. 31);
3. Turn the froth adjustment dial (E1) anticlockwise to the
"INSERT" position (fig. 31) and pull it off upwards;
29
30
Advertisement
Table of Contents
Troubleshooting
