DeLonghi DINAMICA PLUS ECAM37 85 Series Instructions For Use Manual page 22

DISPLAYED MESSAGE
INSERT MILK CONTAINER
INSERT INFUSER ASSEMBLY
WATER CIRCUIT EMPTY
PRESS OK TO START
PRESS OK TO CLEAN OR TURN
DIAL
POSSIBLE CAUSE
The milk container (E) is not inserted correctly.
The infuser (A20) has not been replaced after
cleaning.
The water circuit is empty
:
The milk container has been inserted with
the froth adjustment dial (E1) in the CLEAN
position.
:
REMEDY
Insert the milk container, pushing it as far as
it will go.
Insert the infuser as described in section "12.9
Cleaning the infuser".
Press the selector corresponding to "OK" to
deliver water from the spout (D6) until it flows
out normally.
If the problem persists, make sure the water
tank (A17) is fully inserted.
To proceed with the CLEAN function, press the
selector corresponding to "OK", or turn the froth
adjustment dial to one of the milk positions.
22
→