Quadratec QuadraTop Adventure Top S Manual page 4

Step 3: Pillar and Over Door Surround Assembly and Install Locate the driver's side Rear
over door assembly and the driver's side Pillar assembly shown in FIG12. On the driver's side rear
over door assembly, there is a screw, installed for shipping (Fig 13). Remove this screw and set aside
Driver Side
Over Door Assembly
Passenger Side
Over Door Assembly
Knobs
FIG 12
Passenger
Side Pillar
FIG 14
Line up the Driver's side Rear over door assembly and the driver's side pillar assembly as shown
in Fig 14 & 15 making sure the holes line up. Insert the screw over the top of the hole as shown in
Fig 15. Tighten this screw using the 4mm allen head tool securing the two pieces (Fig 16 & 17).
FIG 16
Repeat the above assembly on the Passenger side Rear over door and pillar assemblies.
Install Door Surrounds to Jeep
Locate the assembled Driver's side rear door surround (Fig18). On the bottom of the vertical pillar
portion of the assembled door surround is a pin that will be inserted into the body tub as shown in
FIG19
FIG 18
Driver Side
Pillar Assembly
FIG 19
4
FIG 13
FIG 15
FIG 17