Quadratec QuadraTop Adventure Top S Manual page 10

Step 8: Installing the Top to the Jeep Body Continued
Go inside the Jeep and locate the long center bow flap. Wrap this bow flap tightly around the
center bow and secure it with the hook and loop fastener (FIGs 62 & 63). you can now reach
through the rear zipper on each side and tighten the corner straps. Alternate tightening to
keep the top centered.Seal hook and loop around windows (Figs 64 & 65).
FIG 61
FIG 62
FIG 64
Step 9: Installing the Tailgate Bar and Rear Window to the body of the Jeep
Take the factory bar and orient the "C"-Channel with the round seal facing down and slide the "C"
Channel onto the rear window retainer as shown in FIG's 66 & 67. After sliding the retainer all the
way through the "C" Channel, roll the tailgate bar into the mounts with the outside of the fabric
facing towards the rear of the Vehicle (Figs 68 & 69).
FIG 66
FIG 68
NOTE: as shown in FIG 61 there is a web
loop installed on the side of the quarter
window.This is to be used for unhooking the
quarter window only and is not designed to
be pulled down on for installation!
FIG 63
FIG 65
FIG 67
FIG 69
10