Table of Contents
Advertisement
ED2400 & ED2400(A) Series Surface Vertical Rod
Exit Devices
Installation Instructions
3
Preparation
b
Mark Door
Locate and mark horizontal and
vertical centerlines as shown. (Figure 6)
LHR door shown. Preparation is typical
for both door hands.
Caution: If device is mounted higher
or lower than shown, rod length must
change. Lengthen or cut top and
bottom rods as shown in Step 4c.
c
Prepare Door, Frame, and Sill
1. Locate Device Template
aligning VERTICAL REFERENCE
and HORIZONTAL REFERENCE
lines on door and template.
Tape template to door face.
(Figure 7)
2. Extend centerline of Rod and
Strikes from Device Template to
top and bottom of door.
3. Locate Top Latch/Strike, Bottom Case, and Bottom Strike templates,
aligned on centerline of Rods and Strikes on door. Tape templates in
place and mark holes.
4. Locate and tape Trim Template to door (see instructions with Trim).
5. Mark and prepare holes per installation template:
• Device and Bolt Case Plates:
Each: (2) 1/4-20 Machine Screws for metal reinforced doors
OR (2) 3/8" (10 mm) Dia. Sex Nuts & Bolts.
• Top Strike ED2400 Series: (2) 10-24 Machine Screws
ED5470 Series: (4) 10-24 Machine Screws.
• Bottom Strike: 5/8" (16 mm) Dia. 3/4" (19 mm) Deep hole.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
2-3/4"
(70 mm)
Vertical reference
Horizontal reference
39-15/16"
(1014 mm)
Door
Finished floor
Finished floor
8
Door
LHR Door
Inside Face
Single
or Pair
Without
Mullion
LHR Door
Top Latch
Inside Frame
& Strike
Rods & Strikes
Template
Vertical
Reference
Device
Horizontal
Template
Reference
Bottom Case
Template
Bottom Strike
Template
Figure 6
Door
Figure 7
FM572 10/22
Advertisement
Table of Contents
