Capturing A Fingerprint - Motion Computing LE1600 User Manual

Capturing a Fingerprint

To capture a fingerprint to enable the fingerprint reader, perform the following steps.
To capture a fingerprint:
1. Tap Motion Dashboard then Security Center panel > Motion OmniPass
> Manage OmniPass Users and Settings > Add a new user to
OmniPass. This step enrolls a new user; you decide on the authentication
method (e.g., fingerprint, digital certificate, etc.).
2. Type in the User Name, Domain, and the Password (if you have one set up)
for this OmniPass account. (This may default to the user name you logged
on with and the password associated with it.)
3. Tap Next to take you to Selecting a Finger and Practicing Fingerprint
Capture.
4. When the Choose Finger window appears, tap the dotted area above the
finger you want to enroll. A red arrow appears above the selected finger.
IMPORTANT: To get a feel for finger position and swipe speed, tap
Practice. "Practice" takes you through all the enrollment steps and
helps you get a successful fingerprint scan. You are asked to scan
the same finger three times.
5. After you have practiced, you will be asked to scan one more time for verifi-
cation. After the verification is successful, tap Next to scan your finger
again, this time for real (not practice).
6. Place the selected finger over the nickel-colored ring and slowly, with mod-
erate pressure, drag your finger across the sensor from right-to-left or left-
to-right. Make sure your entire fingerprint (i.e., your fingertip, not your whole
finger) touches both the nickel-colored ring and the sensor surface.
Successful fingerprint capture: If the capture is successful, you
will see a green fingerprint image in the capture area. If the capture
is unsuccessful, an information message appears, such as "Scan
Motion Computing LE-Series and LS-Series Tablet PCs User Guide 47