Table of Contents
Advertisement
0
1
2
3 - 4
5 - 6
4.2.2.28 "Suspend/Unsuspend" command
The purpose of this command is to suspend tracking due to battery low, as well as to suspend tracking when the unit is
in the "waiting to activate" state. If this command is issued with an argument for "full suspend" when the unit is not in
track, and then a "proprietary track" command is issued while in that suspended state, this condition shall be defined as
"waiting to activate" state, and the unit will begin tracking when this command is received with the "unsuspend" or
"partial suspend" argument.
The Nordic processor uses this command to transition from "battery very low", "battery low" and "battery OK" states.
Byte
0
1
2
3 - 4
5 - 6
Response: AA 05 80 <CRC>
4.2.2.29 Suspended State query
Use or disclosure of data contained on this sheet is subject to the restrictions in the Distribution Statements on the title page of this
06/18/20
0 – 7
Leader
0 – 7
Length
0 – 7
Command Code.
0 - 15
Rate
0 – 15
CRC
Suspend/Unsuspend command
Bits
Parameter
0 – 7
Leader
0 – 7
Length
0 – 7
Command Code.
0 - 7
Mode argument
0 – 15
CRC
Suspended State query
GLOBALSTAR PROPRIETARY AND CONFIDENTIAL INFORMATION
Subject to Change without Notice
Always a value of 0xAA.
0x07
0x85 = Query minimum track rate
Rate in minutes, MSB first
Description
Always a value of 0xAA.
0x06
0x80 = Suspend / Unsuspend
0x00 = Full Suspend stop tracking messages
completely
0x01 = Partial suspend reduce tracking rate to
low battery rate
0x02 = Unsuspend. Track at normal tracking
rate
document.
P a g e | 56
Advertisement
Table of Contents
