Table of Contents
Advertisement
2.2 Block Diagram
2.3 Handling of Electrostatic Sensitive Devices
Some components on the ST100 PCB are sensitive to electrostatic discharge (ESD). The following general guidelines can
help reduce damage due to ESD.
1. Use a grounding bracelet if possible, to minimize charge build-up on personnel.
2. Handle the ST100 PCB by the long edges without touching components or printed circuit paths. The long edges
measure approximately 2" (50.8mm). The short edges measure approximately 1" (25.4mm). Note: There are ESD
sensitive devices located closer to the short edges than the long edges.
3. Store the ST100 PCB in static sensitive packaging whenever possible.
GLOBALSTAR PROPRIETARY AND CONFIDENTIAL INFORMATION
Use or disclosure of data contained on this sheet is subject to the restrictions in the Distribution Statements on the title page of this
document.
06/18/20
Subject to Change without Notice
P a g e | 13
Advertisement
Table of Contents
