Pin Connector - Globalstar ST100 User Manual

tested as acceptable.
2. The VAR/installer should review the pairing of solar panel / battery and determine if the solar panel is
adequate for use with the selected battery.
3. This value is based on the efficiency of the solar charger chip, which is typically 80-85%.
4. The solar panel should be chosen for outdoor use, if the end-application will be mostly outdoors.

2.8.4 14 Pin Connector

Pin # Signal Name
1 3V0
2 SWDIO
3 GND
4 SWDCLK
5 GND
6 SAT_DBG_DATA
7 SAT_DBG_CLK
8 SAT_DBG_EN
9 SAT_RST_N
10 EXT_TX_CONN
11 EXT_RTS_CONN
12 MCU/BLE_#RESET
13 EXT_CTS_CONN
14 EXT_RX_CONN
Notes
1. The mating cable for Molex 5034801400 is Molex part # 0152660153, or equivalent.
Use or disclosure of data contained on this sheet is subject to the restrictions in the Distribution Statements on the title page of this
06/18/20
Table 3 – 14 pin Connector (Molex 5034801400)
Description
3V supply
Bluetooth processor programming line
PCB Ground
Bluetooth processor programming line
PCB Ground
ASIC programming line
ASIC programming line
ASIC programming line
ASIC reset
External Serial Port Transmit
External Serial Port Request to Send
Bluetooth processor reset
External Serial Port Clear to Send
External Serial Port Receive
GLOBALSTAR PROPRIETARY AND CONFIDENTIAL INFORMATION
document.
Subject to Change without Notice
Notes
The 3V supply is only meant to
power loads less than 20mA
This is the Receive signal on the
Bluetooth processor.
This is a GPIO signal connected
to the Bluetooth processor
This is a GPIO signal connected
to the Bluetooth processor
This is the Transmit signal on the
Bluetooth processor.
P a g e | 18