Table of Contents
Advertisement
CONTROL PANEL OPERATION
1) Magnet ON
2) Motor switch
Move the mechanical magnet switch, located on the
When the magnet is in the ON position, the GREEN
back of the magnet to the ON position. The LED will
switch will light up to indicate the motor is ready to start.
light up either red of green depending on if sufficient
magnetic adhesion has been achieved.
3) Magnet ON
4) Cutting
1) Magnet OFF
Press the GREEN Switch to turn
See next page for detailed
To stop the motor, press the RED
the motor on. Procees with cutting
decription of the CutSmart
switch. The motor will stop, and the
TM
following all safety guidelines...
visual indicator.
GREEN switch will turn on.
Go back to step 3 to start over.
10
Advertisement
Table of Contents
Need help?
Do you have a question about the Element 40 PERM and is the answer not in the manual?
Questions and answers