Fitting The Chuck; Maintenance Checks - Rotabroach Element 40 PERM Manual

FITTING THE CHUCK

• To remove the arbor lay the machine on its side.
• Unscrew the two grub screws at the top of the arbor.
• When the arbor has become detached from the spindle this can then be removed.
• Remove the arbor support bracket and guard with the arbor retained.
• Mount the chuck using the chuck adaptor RD33153.
• Replacing the chuck is the reverse sequence.
MAINTENANCE
In order to 'get the best life' out of your Rotabroach machine always keep it in good working order.
A number of items must always be checked on Rotabroach machines.
Always before starting any job make sure the machine is in good working order and that there are
no damaged or loose parts. Any loose parts must be tightened.
Before proceeding with any maintenance work be certain that the power supply is
disconnected.
Description
Visual check of machine
for damage
Operation of machine
Check brush wear
Check magnetic base
Check alignment of the
machine
Check grease
Check armature
Visually check the machine for damage.
The machine must be checked before operation for any signs of damage that will affect the
operation of the machine. Particular notice must be taken to the mains cable, if the machine
appears to be damaged it should not be used, failure to do so may cause injury or death.
Check operation of the machine.
The machines operation must be checked to ensure that all components are working correctly.
Machine Brushes
Should be checked to make sure there is no abnormal wear present (this should be checked at
least once a week if used frequently). If the brush has worn more than 2/3 of the original length, the
brushes should be changed. Failure to do so may cause damage to the machine.
22
Every Operation
X
X
X
1 Week
X
1 Month
X
X
X