Hart Parameters - Siemens SITRANS F Operating Instructions Manual

2. Select: "Device->Download to device".
3. Select "Execute even if the device TAG does not match the project data TAG" and click
6.4.3

HART parameters

The available parameters are grouped into the following blocks:
Identification
General information on devices that enable the clear definition of the device is deposited in
this parameter block.
The following parameters can be deposited:
● TAG
● Description
● Date
● Message
● Works number
Basic settings
The time response of the MEM is set in this parameter block.
● Damping
SITRANS FVA250
Operating Instructions, 02/2013, A5E03821131-01
"OK".
A time constant within the range of 0 to 60 seconds can be selected via these
parameters. On expiry of this time the measured value reaches 63.7% of the final
condition with an abrupt change of the input signal.
Commissioning
6.4 Configuring with HART
37