Exit General Project Setting; P Parameter Setting; P1 Motor Characteristic Parameter Setting - KUNTENG KT-LCD11 User Manual

ELECTRIC BICYCLE METER KT—LCD11 Product User Manual
mileage
Under the metric/imperial units setting interface, if there's no button operation
on the meter for more than 1 minute, and then the meter will automatically return to
display 1, and the original set units will be saved.
After finishing the metric/imperial units setting, press
save the current set values, and then speed and mileage units stop flashing, or hold
button (SW) long for about 2 seconds to exit the general project setting environment and
return to display 1.
○

Exit General Project Setting

Among the three general project settings, after each setting is completed, if hold
button (SW) long for about 2 seconds, all can exit the setting environment and return to
display 1, meanwhile, the current set parameters are saved.
Under each setting interface, if there's no button operation on the meter for more than
1 minute, and then the meter will automatically return to display 1, and the original set
parameters will be saved.

P Parameter Setting

After finishing metric/imperial unit settings, the speed and mileage units stop flashing.
Press button (DOWN) to enter P Parameters Setting.
○

P1 Motor Characteristic Parameter Setting

P1 is motor characteristic parameter setting, P1 = motor gear reduction ratio× number
of motor magnet pieces, just rounding if there's any decimal.
After entering P parameter setting environment, the first is to set P1parameter, P1
parameter column flashes. P1 setting ranges between1-255, press
button (DOWN) for selection.
MPH
- 16 -
Mil
button shortly (SW) to
button (UP) or