Exit General Project Setting; P Parameter Setting; P1 Motor Characteristic Parameter Setting - KUNTENG KT-LCD8Y User Manual

ELECTRIC BICYCLE METER KT—LCD8H Product User Manual
Code Speed
0
1
2
3
Under the metric/imperial units setting interface, if there's no button operation
on the meter for more than 1 minute, and then the meter will automatically return to
display 1, and the original set units will be saved.
After finishing the metric/imperial units setting, press
current set values, and then speed and mileage units stop flashing, or hold
(SW) long for about 2 seconds to exit the general project setting environment and return to
display 1.
○

Exit General Project Setting

Among the three general project settings, after each setting is completed, if hold
button (SW) long for about 2 seconds, all can exit the setting environment and return to
display 1, meanwhile, the current set parameters are saved.
Under each setting interface, if there's no button operation on the meter for more than
1 minute, and then the meter will automatically return to display 1, and the original set
parameters will be saved.

P Parameter Setting

After finishing metric/imperial unit settings, the speed and mileage units stop flashing.
Press button (DOWN) to enter P Parameters Setting.
○

P1 Motor Characteristic Parameter Setting

P1 is motor characteristic parameter setting, P1 = motor gear reduction ratio× number
Mileage
Km/h
MPH
Km/h
MPH
℃(Centigrade temperature)
Km
℃(Centigrade temperature)
Mil
Km
Mil
i
button shortly to save the
- 17 -
Ambient temperature
℉（Fahrenheit）
℉（Fahrenheit）
button