Eneo MEB-55M2812M0A User Manual page 15

2. Power on the camera, the DVR and the monitor, and then view the image on the monitor.
3. Open the DVR main menu, and enter into the menu <Device-->PTZ-->Protocol> and
configure the protocol to <Coax>;
4. Go to Live view interface and left-click the bottom on the specific
live channel, then select the PTZ control icon 【 】 to pop up the
following interface shown as Pic 17
】to go to hybrid HD camera OSD menu. This
5. Click the icon【
icon is also to be used as Confirm icon. Up, down and right and left
buttons 【 】are used to select the menu.
6. Now you have called the OSD menu of the camera by PTZ
Control Interface via DVR port. Details please refer to the picture
shown as Pic 18.
Pic.17
Pic.18
14