Control Names - Mitsubishi Diamond Pro 87TXM User Manual

3.1

Control Names

1. POWER SWITCH: A push-on push-off switch for AC power.
2. POWER-ON INDICATOR: This indicator illuminates when AC power is on.
3. RESET BUTTON: Push the RESET button to restore a factory preset that has been
modified by the user. This button performs two functions under different conditions.
1. When adjusting H-SIZE, H-PHASE, V-SIZE, V-POSI, PCC-AMP, PCC-
PHASE, PIN-BALANCE, KEY-BALANCE, MOIRE-CLEAR(ON/OFF),
MOIRE-CLEAR LEVEL, CENTER-PCC, TOP-PCC, BOTTOM-PCC, and
CLAMP-PULSE POSITION, pressing the RESET button will restore the
factory adjusted screen geometry and size settings, if the current video signal
timing corresponds to a factory preset timing.
2. When adjusting color gains, pressing the RESET button will restore the
factory adjusted color gain for the currently selected color memory number.
4. OSD OFF BUTTON: A push type button that is used to turn off the OSD.
5. FUNCTION SELECT BUTTONS: Push the four directional (Up,Down,Left,Right)
buttons to select one of the functions that is superimposed on the display screen.
6. ADJUST BUTTONS: Push the buttons to adjust the image on the screen that is
selected via the function select buttons.
7. DEGAUSS BUTTON: A push type button that is used to eliminate possible color
shading or impurity.
8. SERIAL INTERFACE CONNECTOR: The monitor has a DIN-8P connector for
connecting to the computer when using the optional serial interface kit. For
information about connecting the serial interface, please refer to the instructions
included with the serial interface kit.
For further information about the optional serial interface kit please contact your
authorized MITSUBISHI dealer.
18