Table of Contents
Advertisement
2.7
AC INPUT POWER
Before connecting the monitor to the power source,
determine that the line voltage and frequency are proper
{100 - 120V AC or 220 - 240V AC, 50/60 Hz).
Check the position of the input voltage plug (PG) on the
PCB-POWER.
Make certain that the plug (PG) is in the
proper position for the input line voltage {100 - 120V
AC or 220 - 240V AC, 50/60 Hz).
Plug the ac line cord
into the power receptacle on the rear panel.
2.8
DEGAUSSING AND BRIGHTNESS CONTROL
Turn on the "POWER SWITCH" and adjust the brightness
control.
The raster will then become visible in
approximately 30 seconds.
Push the degauss switch and
a rainblow pattern will appear momentarily, then release
the degauss switch.
2-3
Advertisement
Table of Contents
