Table of Contents
Advertisement
Operation
6.3 Measuring menu
Acknowledging alarms
Alarms are acknowledged as follows:
Press the <ACK> button for 5 seconds to reset the alarm. "rES" flashes in the digital display
for 5 seconds. The alarm is then reset.
Note
If no alarm was set, "noAL" is shown to the left in the middle section of the digital display.
Note
Condition
Alarms can only be acknowledged if the parameter value is set to "P.14/ACK" = "¬St.Ac" or
"St.Ac".
See also
Parameter list (Page 51)
42
SITRANS DA400 for oscillating positive displacement pumps
Operating Instructions, 09/2008, A5E00841120-03
Advertisement
Table of Contents
