Extra Commands; Tcp/Ip Or Udp/Ip Frame Setup With Reed Solomon Fec - Safran CORTEX RTR NeXt Series User Manual

4. Extra commands

Path : [
HKLM\SOFTWARE\IN-SNEC\rtrnt\common\extracmd
Register Key
reset_ctx_enabled
reset_ip_enabled
shutdown
The 3 extra commands are defined in document [AD3]

5. TCP/IP or UDP/IP frame setup with Reed Solomon FEC

Path : [
HKLM\SOFTWARE\IN-SNEC\rtrnt\common\fec\rs
Register Key
SyncWordEnable
CheckSymbEnable
InterleavingEnable
SyncWord
© Safran Data Systems – IMP000074 e14r1
Radio Telemetry Receiver
User's Manual
Type
DWORD Authorization for receiving an extra command to restore the software
default configuration
0 : not authorized
1 : authorized (Default)
Default : 1
DWORD Authorization for receiving an extra command to initialize the Ethernet
ports configuration.
0 : not authorized
1 : authorized (Default)
DWORD Authorization for receiving an extra command to switch off the
equipment.
0 : not authorized
1 : authorized (Default) - for RX1 only
Type
DWORD RS Frame Sync Word transmission :
0 : disable
1 : enable (Default)
DWORD RS Check symbols transmission:
0 : disable
1 : enable (Default)
DWORD RS interleave :
0 : disable
1 : enable (Default)
DWORD RS syncword transmitted after decoding.
Defaut : 0x1ACFFC1D
Note : Specific application with GMDR, the ASM pattern can be changed
after decoding.
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. D104004
Is.Rev 07
Previous Ref.:
Date: 21/06/2021
]
Description / Default Value
]
Description / Default Value
Safran Data Systems
DTU000567
.
Page 92