Table of Contents
Advertisement
Automatic operation of the air conditioning system is switched on
4
Intensive windshield defroster switched on
5
Direction of air flow
6
Recirculated air mode activated
7
Cooling system activated
8
Set blower speed
9
Set the temperature (turn to the left: Reduce fan speed, turn to the right:
10
Increase blower speed)
Interior temperature sensor
11
Switching the intensive windshield defroster on/off - when this function
is switched on, the warning light illuminates in the button
Switching automatic mode on
Switching the airflow to the windows on and off
Switching the airflow to the upper body on and off
Switching the airflow to the footwell on and off
Switch recirculated air on/off
Switch the cooling system on/off
After the cooling system is switched off, only the ventilation function remains
active, whereby the lowest temperature that can be reached is the outside
temperature.
Setting temperature
The set temperature value appears in the display (pos.
The interior temperature can be set between +16 ℃ and +29 ℃. The interior
temperature is regulated automatically within this range.
If you set the temperature to below +16 °C, "LO" appears in the display.
If you set the temperature to higher than +29 ℃, "HI" appears in the display.
At both end positions, Climatronic runs at maximum cooling/heating output
and the temperature is automatically not regulated.
Switching between Celsius and Fahrenheit
Press buttons and simultaneously and hold for about 2 seconds.
The information appears in the display in the desired temperature measure-
ment unit (pos.
» Fig.
104).
3
All manuals and user guides at all-guides.com
» page 96
» Fig.
104).
2
Controlling blower
The Climatronic system controls the blower stages automatically in line with
the interior- and ambient temperatures. However, the blower level can be
manually adjusted to suit your particular needs.
If the blower speed is reduced to a minimum, Climatronic is switched off.
The set blower speed is indicated by the corresponding number of segments
(pos.
» Fig.
104) in the display.
9
Automatic mode
The automatic mode is used in order to maintain a constant temperature and
to demist the windows in the interior of the car.
To switch on press the button. The display shows (pos.
Automatic mode can be switched off by pressing any of the air distribution
buttons or by increasing/decreasing the blower speed. The temperature is
nevertheless regulated.
WARNING
Do not switch off the Climatronic system for longer than necessary.
■
Switch on the Climatronic system as soon as the windows mist up.
■
Note
Do not stick anything onto or cover the interior temperature sensor
■
» Fig. 104
as this can have an unfavourable effect on the Climatronic system.
As soon as the windscreen mists up, press the symbol button . Press the
■
button once the windscreen has demisted.
During operation of the Climatronic, under certain circumstances an increase
■
in engine idle speed can occur in order to ensure adequate heating comfort.
Efficient handling of the cooling system
Read and observe
and
on page 95 first.
The air conditioning system compressor uses power from the engine when in
cooling mode, which will affect the fuel consumption.
It recommended to open the windows or the doors of a vehicle for which the
interior has been strongly heated through the effect of direct sunlight in order
to allow the heated air to escape.
The cooling system should not be switched on if the windows are open.
» Fig.
104).
4
11
99
Heating and air conditioning
Advertisement
Chapters
Table of Contents
