Positioning Transparent Film - Microtek ScanMaker i900 Supplementary Manual

Positioning Transparent Film

This procedure applies when you use the lower scan bed of the ScanMaker i900.
There are two ways to scan transparent film:
A. By using the Glass Holder to scan non-standard-size transparent film.
Glass Holder
Important:
When using the Main Holder or the Glass Holder, make sure you use the correct
side up when inserting the holders into the scanner. The correct side up is the
side showing the holder labels facing up.
Make sure that the calibration strip on the holders are kept clear and free of
obstruction at all times; no material should ever be placed on this area. Also, make
sure the calibration strip faces the front of the scanner when you insert the
holders into the lower compartment of the ScanMaker i900.
B. By using the Main Holder, which is used together with individual film holders to
scan standard-size transparent film, such as 35mm slides, 35mm filmstrips, 120 film,
or 4" x 5" film.
Calibration strip
Main Holder
Calibration strip
4 " x 5 " Film Holder
Vinyl strip
ScanMaker i900 Supplement 9