Connecting To The Firewire Port - Microtek ScanMaker i900 Supplementary Manual

Connecting to the FireWire Port

The printed Start Here guide showed you how to connect your computer to the USB
port of the ScanMaker i900. Here, the Supplement shows you how to connect the
computer to the scanner's alternate FireWire port.
Prior to connection, check first to see if your computer system has a FireWire port. If
FireWire is present, connect the FireWire cable to the FireWire port. If your computer
does not have a FireWire port, install a FireWire card to make use of the FireWire port.
For details on how to install a FireWire card in your computer, refer to the
documentation that came with the FireWire card.
Note: Your ScanMaker i900 does not include a FireWire card in the package.
Follow the steps below to perform the FireWire connection:
1. Connect one end of the FireWire cable to your computer, and connect the other
end of the cable to the scanner's FireWire port.
For PC users
(with a built-in FireWire port
or FireWire card installed)
For Mac users
(with a built-in FireWire port)
The latest Macintosh
computers (i.e., G3, G4, G5,
etc.) are equipped with a built-
in FireWire port, usually
labeled with the " " logo.
ScanMaker i900 Supplement 5