Microtek ScanMaker i900 Supplementary Manual page 13

c) Align the frame-by-frame
partition on your filmstrip with
the Arrow mark of the holder.
d) Snap to close the lid.
The partitions on the holder
should match the filmstrip's
frame-by-frame partitions.
2. Put the 35mm Filmstrip Holder
into the Main Holder.
3. Insert the whole assembly
into the transparency bay of
the scanner.
Caution:
When the filmstrips are closed, do not move or touch the filmstrips. If you do so, this
will bend the original that may result in out-of-focus scans.
Frame-by frame
partition
Orient Main Holder with "Main
Holder" label facing up
ScanMaker i900 Supplement 13