Calibration Setup - Microtek ScanMaker i900 Supplementary Manual

32 ScanMaker i900 Supplement

Calibration Setup

With the target properly positioned on the scanner, turn on your scanner and
let it warm up for about five minutes. Launch the MSP program; the MSP main
window appears.
A. Choose the scanner model that you are calibrating.
B. Choose the correct target media. If you are calibrating the reflective target, select
Reflective. Otherwise, select Positive.
C. Select the date code and target type from the
drop-down list that matches your target. You can
verify this information by looking at the left and
right corners of the target's bottom margin.
D. When all the settings are done, click the Start button. The calibration window will
appear, and an initial preview of the target is performed.
A
B
C
D
Date code and target type
information