Maserati Levante Owner's Manual page 165

NOTE:
To set drive parameters according to
own needs and path, refer to chapter
"Drive Mode" and "Off-road Drive" in
section "Driving".
Press and release the ◄ button to
return to the main menu.
4. DRIVER ASSIST
Press and release the switch in the ▲
or ▼ arrow directions until this menu
item is displayed.
• Active Driver Assist System
The screen graphically shows
current status of driver assist
systems: the figure shows an
example with ACC set and LDW
armed.
• LDW (LaneSense) Status
Vehicle is delivered with LDW in
"Off" state set on MTC+ system.
You can enable LDW in the "Sound
+ Display" mode or disable it
permanently (it means that
maintains this condition even after
a key-off/key-on cycle) by holding
down the switch (►) on the right
side of the steering wheel
(condition shown in picture). If LDW
is enabled or disabled via MTC +
system, after each key-off/key-on
cycle the system returns to the
previous state before turning off
the vehicle.
Dashboard Instruments and Controls
NOTE:
To set these systems, see chapters
"Adaptive Cruise Control - ACC
(optional)" and "Lane Departure
Warning - LDW (optional)" in section
"Driving".
Press and release the ◄ button to
return to the main menu.
5. FUEL ECONOMY
Press and release the switch in the ▲
or ▼ arrow directions until this menu
item is displayed.
The screen will display the following:
• Current Fuel Economy in l/100km or
mpg
Shows the current fuel economy.
During AutoStop stage performed
by the Start&Stop system (see
"Normal Starting of the Engine" in
section "Driving"), a dash will be
displayed instead of the value.
4
163