Maserati Levante Owner's Manual page 148

Understanding the Vehicle
has been acquired and programmed
correctly by the HomeLink
NOTE:
The distance necessary between the
portable hand-held transmitter and
®
the HomeLink in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
3
several times. Upon every attempt,
keep the setting position for at least
15 seconds before trying again.
• Press and hold the programmed
®
HomeLink button.
If the garage door opener/device
activates, programming is complete. To
program the remaining two
®
HomeLink buttons, repeat each step
for each remaining button. Do not
erase the channels.
Reprogramming a Single HomeLink
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the RUN
position without starting the engine.
• Press and hold the desired
®
HomeLink button.
• Without releasing the button
proceed with "Programming the
146
hand-held transmitters" from second
®
system. step and follow all remaining steps.
Using HomeLink
To operate, press and release the
programmed HomeLink
Activation will now occur for the
programmed device (i.e., garage door
opener, gate operator, security system,
entry door lock, home/office lighting,
etc.). The hand-held transmitter of the
device may also be used at any time.
Security
It is advisable to erase all channels
before you sell or turn in your vehicle.
To erase the channels press and hold
the two outside HomeLink
and III) until the warning light starts
flashing (after approximately 20
seconds).
®
The HomeLink
disabled when the vehicle security
alarm is active (see "Vehicle security
alarm" in section "Before Starting").
Troubleshooting Tips
If you are having trouble while
programming HomeLink
some of the most common solutions:
• Replace the battery in the original
hand-held transmitter.
®
®
button.
®
buttons (I
®
Universal Transceiver is
®
, here are
• Press the LEARN button on the
garage door opener to complete the
training for a rolling code.
• Did you unplug the device for
programming and forgot to plug it
back in?
If you have any problems, or require
assistance, please call toll-free
1–800–355–3515 or, on the Internet at
www.HomeLink.com for information
or assistance.