Maserati Levante Owner's Manual page 103

• The "S" (SET) button, which is used
to activate the memory save
function.
• The "1" and "2" buttons which are
used to recall either of two
programmed memory profiles.
Memory Profiles Setting
NOTE:
Saving a new memory profile will
erase an existing profile from memory.
To create a new memory profile,
perform the following:
• Cycle the ignition device to the ACC
or RUN position.
• Adjust all memory profile settings to
desired preferences (i.e., seat, side
mirrors, adjustable pedals (optional),
power tilt and telescopic steering
column, and radio station presets).
• Press and release the "S" button on
the memory switch.
• Within 5 seconds, press and release
the memory button "1" or "2".
• Check on the instrument cluster for
the positive response of the actions
"Memory 1 (or 2) profile set".
After these steps, the profile set will
be memorized in the selected position.
NOTE:
Memory profiles can be set without
the vehicle in P (Park), but the vehicle
must be in P (Park) to recall a memory
profile.
Pairing Remote Keyless Entry
Transmitter to Seats Memory
Your key fob with RKE transmitters
can be programmed to recall one of
two programmed memory profiles by
pressing the button on the RKE
transmitter.
NOTE:
This feature can be enabled or
disabled using the MTC+ System, refer
to "MTC+ Settings" in section
"Dashboard Instruments and
Controls" for further information.
Understanding the Vehicle
To programme your key fobs RKE
transmitter, perform the following
actions:
• Cycle the ignition device to the ACC
or RUN position.
• Move the seat and/or the other
adjustable devices in the position
that you wish to memorize, or recall
a previously memorized profile,
pressing the corresponding memory
button "1" or "2".
• Cycle the ignition device to the OFF
position.
• Press and release the "S" button.
• Within 5 seconds, press and release
the memory button "1" or "2".
• Press and release the button on
key fob RKE transmitter.
• Within 3 seconds, press and release
the button on the key fob RKE
transmitter.
To check if the system has memorized
the correct profile, you can move the
seat and press the button: the seat
will move to the memorized position.
3
101