Maserati Levante Owner's Manual page 146

Understanding the Vehicle
WARNING!
• Your motorized door or gate will
open and close while you are
programming the universal
transceiver. Do not program the
transceiver if people, pets or other
objects are in the path of the door or
3
gate. Only use this transceiver with a
garage door opener that has a "stop
and reverse" feature. Do not use a
garage door opener without these
safety features. Call toll-free
1–800–355–3515 or, on the Internet
at www.HomeLink.com for safety
information or assistance.
• Vehicle exhaust contains carbon
monoxide, a dangerous gas. Do not
run your vehicle in the garage while
programming the transceiver.
Exhaust gas can cause serious injury
or death.
Before You Start Programming
®
HomeLink
Be sure that your vehicle is parked
outside of the garage before you
begin programming.
For more efficient programming and
accurate transmission of the
radio-frequency signal it is
144
recommended that a new battery be
placed in the hand-held transmitter of
the device that is being programmed
®
to the HomeLink system.
Before starting programming it is
necessary to erase the standard codes
memorized on the HomeLink
during the production phase. To erase
such codes:
• place the ignition device in the RUN
position without starting the engine;
• press and hold the two outside
®
HomeLink buttons (I and III) until
the warning light starts flashing
(after approximately 20 seconds);
• release the buttons.
NOTE:
• Erasing the standard codes should
only be performed when
®
programming HomeLink
first time. Do not perform this
operation to program additional
buttons.
• If you have any problems, or require
assistance, please call toll-free
1–800–355–3515 or, on the Internet
at www.HomeLink.com for
information or assistance.
®
device
System with Devices Provided
with Rolling Codes
Programming the Hand-held
Transmitters Manufactured after 1995
These devices can be identified by the
"LEARN" or "TRAIN" setting button
located where the hanging antenna is
attached to the garage door/gate
opener. It is NOT the button that is
normally used to open and close the
for the
door.
The name and color of the button may
vary by manufacturer.
• Place the ignition device to the RUN
position without starting the engine.
• Place the hand-held transmitter 5 -
30 cm (1 to 3 inches) away from the
®
HomeLink
program.
button you wish to