Maserati Levante Owner's Manual page 120

Understanding the Vehicle
High Beams and Flashing
To switch on the high beams with the
light switch in headlamp
"AUTO" position, shift the
multifunction lever onward.
The blue telltale
the tachometer.
3
By pulling the lever backward (toward
the steering wheel) you switch off the
high beams and switch on the low
beams.
118
You can signal another vehicle with
your headlights by lightly pulling the
multifunction lever toward you. This
or
will turn on the high beams headlights
until the lever is released.
will illuminate on
Flashing occurs also with lights off
(lights switch in position "0") if the
ignition switch is RUN position.
The high beams can only be switched
on manually by pushing the
multifunction lever forward.
If the high beams have been switched
on, they will turn on automatically
every time the low beams are
switched on either manually or
CAUTION!
WARNING!
automatically. We recommend
therefore that you switch them off
when they are no longer necessary
and every time the twilight sensor
deactivates the external lights.
Automatic High Beams (if equipped)
The Automatic High Beam headlight
control system provides increased
forward lighting at night by
automating high beam control
through the use of a digital camera
mounted behind the rearview mirror,
which is the same one used also by the
Lane Departure Warning (LDW)
system. This camera detects vehicle
specific light and automatically
switches from high beams to low
beams until the approaching vehicle is
out of view. Futhermore, the digital
camera is able to detect the urban
areas and the inhabited centers and to
turn off the high beams when driving
near of one of them.
The high beam can be turned back on
if there are all the necessary conditions
and if the vehicle speed exceed
35 km/h (21.7 mph).
The Automatic High Beam function
can be turned on or off using the
MTC+ System. Refer to "MTC+
Settings" in section "Dashboard