Maserati Levante Owner's Manual page 147

• Simultaneously press the Homelink
button you want to program and
the hand-held transmitter button.
• Release immediately the Homelink
button you want to program.
• Continue holding the hand-held
transmitter button until the warning
light starts flashing quickly; then
release the button.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
®
correctly by the HomeLink
NOTE:
The distance necessary between the
portable hand-held transmitter and
®
the HomeLink in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
several times. Upon every attempt,
keep the setting position for at least
15 seconds before trying again.
Synchronising the Rolling Codes
At the end of the previously-described
programming, if the HomeLink
been programmed for a rolling code
system, it will be necessary to
synchronise it to ensure its correct
operation.
®
• Locate the "LEARN" or "TRAINING"
setting button of the opening motor.
Firmly press it and then release it. On
some garage door openers/devices
®
there may be a light that blinks
when the garage door opener/device
is in the LEARN/TRAIN mode.
NOTE:
You have 30 seconds to initiate the
next step after the setting button has
been pressed.
system.
• Return to the vehicle and press the
programmed HomeLink
two seconds and then release it.
• Repeat this operation a second time.
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button a
third time for two seconds and then
release it to complete the
programming/synchronization phase.
®
has
• To program the remaining two
®
HomeLink
step for the same remaining button.
DO NOT erase the channels.
®
button for
buttons, repeat the same
Understanding the Vehicle
Reprogramming a Single HomeLink
Button
To reprogramme a channel that has
been previously trained, follow these
steps:
• Place the ignition device to the RUN
position without starting the engine.
• Press and hold the desired
®
HomeLink button.
• Without releasing the button
proceed with "Programming the
hand-held transmitters" from second
step and follow all remaining steps.
System with Devices Without
Rolling Code
Programming the Hand-held
Transmitters Manufactured before
1995
• Turn the ignition device to the RUN
position without starting the engine.
• Place the hand-held transmitter 5 to
30 cm (1 to 3 inches) away from the
®
HomeLink button you wish to
program.
• Simultaneously press and hold both
buttons until the warning light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
®
3
145