Table of Contents
Advertisement
Available languages
Available languages
EN
Wireless Footswitch Operation
LED indicators
1
The included wireless footswitch provides quick access to preset colors, color-change programs, and sound-activation
through the 4BAR Quad ILS microphone.
To use the footswitch:
1. Connect the 4BAR Quad ILS to power. Turn the wireless footswitch on.
2. Press <MENU> repeatedly until SEt shows on the display, and press <ENTER>.
3. Use <UP> or <DOWN> to select ir, and press <ENTER>.
4. Use <UP> or <DOWN> to select on, and press <ENTER>.
5. Press <MENU> repeatedly until P-- shows on the display, and press <ENTER>.
6. Press pedal #3 to activate static color controls. When working, all the lights will begin in a static color and FOOt
will appear on the Menu display.
7. Use the chart below to activate the desired function.
Pedal
1
Tap pedal to activate, then tap to
(Auto Programs)
2
(Sound Mode)
3
(Static Colors)
4
(Blackout)
The 4BAR Quad ILS footswitch will work properly in any mode, with a maximum unobstructed distance of
100 ft (30.5 m). You must turn on the ir setting from the 4BAR Quad ILS and navigate to Auto mode before
using the footswitch.
Footswitch Battery
The wireless footswitch uses a 9-volt battery located under the battery cover on the bottom of the product, which can be
replaced when necessary.
Battery Replacement
To replace the battery in the wireless footswitch:
1. Turn the power switch to the Off position.
2. Remove the battery cover by removing 2 screws with a Phillips-head screwdriver.
3. Remove the old battery from the housing and unplug it from the leads.
4. Replace with a new 9-volt battery, ensuring that the positive (+) and negative (-) leads correspond to the correct
electrodes on the battery.
5. Place the battery into the housing and cover with the battery cover.
6. Secure the battery cover with the 2 Phillips-head screws.
Do NOT over-tighten the screws!
5
QUICK REFERENCE GUIDE
3
2
Action
navigate to desired function
Press and hold
Tap
Press and hold
Tap
Press and hold
Power switch
4
9-volt battery cover
Function
Auto programs 1–8
Sound-active programs
Static colors C1–18
Auto snap program
Auto fade program
Auto fade program
Blackout
Fade to blackout
4BAR Quad ILS QRG Rev. 3
Advertisement
Table of Contents
