Assembling Components And Use Of Accessories - Optimum THERMOCOOK ESSENTIAL User Manual

ASSEMBLING COMPONENTS AND USE OF
ACCESSORIES
DRIVE COUPLING
If not already fitted to the bottom of the jar, the drive coupling and rubber sealing gasket must be
fitted and secured properly.
To do this, take the drive coupling and ensure the rubber gasket is fitted over the bottom of the
coupling as shown below.
Failure to fit the rubber sealing gasket will allow liquids to escape out the bottom of the
jar. From the top of the jar, lower the drive coupling down and through the hexagonal hole
in the bottom of the jar.
NOTE: The drive coupling can only be fully inserted into the hexagonal hole in three positions. Not
six positions of the hexagonal hole. So, if the drive coupling cannot be inserted all the way into the
hole, rotate the drive coupling one notch and push in.
Whilst holding the drive coupling in place, flip the jar upside down.
Take the locking collet with your other hand and with the arrow on the collet aligned with the
Unlocked Padlock symbol on the base of the jar, push the locking collet down, then with some force,
rotate clockwise until the arrow is aligned with the Locked Padlock symbol to seal and lock the Drive
Coupling in place.
9