Canon imageCLASS MF746Cdw User Manual page 632

14
Gently close the feeder or the platen glass cover.
If the <Could not perform correction.> message is displayed
● Did you load the paper displayed in step 4 into the paper source?
● Did you place the adjustment image with the print side face down, with the black stripe toward the back side
of the machine?
● Has a paper jam occurred? For more information, see "Troubleshooting (FAQ)" on the online manual
website.
● Is the amount remaining in toner cartridge sufficient? If the amount remaining in the toner cartridge is low,
it is recommended that you replace the toner cartridge.
Consumables(P. 618)
● Is the transfer belt inside the machine dirty?
Quick Adjust
This adjustment maintains the optimized status that was acquired by <Full Adjust>. If the result of this adjustment is
not satisfactory, perform <Full Adjust>. This adjustment may be automatically performed after you replace a toner
cartridge.
● Quick adjustment is not available while scanning or printing is performed.
● You can also configure so that a quick adjustment is automatically performed immediately after the machine
is turned ON or when a first print job is performed.
1
Select <Menu> in the Home screen.
2
Select <Adjustment/Maintenance>
Gradation>.
3
Select <Quick Adjust>.
4
Select <Start>.
➠
The adjustment starts.
Adjust Copy Image
Use this adjustment when the appearance of copy is extremely different from that of the original. The adjustment
operation is to "print out the adjustment image and scan it." Note that you cannot perform this adjustment while
performing some functions such as scanning and printing.
Maintenance
Checking the Remaining Amount of
Cleaning the Transfer Belt (ITB)(P. 612)
<Auto Correction Settings>(P. 489)
Home Screen(P. 126)
<Adjust Image Quality>
624
<Auto Adjust