Stop Appliance Services Via The Console; Start Appliance Services Via The Console - Cisco MARS Install And Setup Manual

Chapter 6 Administering the MARS Appliance
•
All services should be running on a Local Controller. However, a Global Controller only has three
Note
services running: graphgen, pnarchiver, and superV—all other services are stopped.

Stop Appliance Services via the Console

You can stop all MARS Appliance services from the console. To list the services and their status, you
can use the pnstatus command. For more information, see
via the Console, page
To stop all services on the MARS Appliance, follow these steps:
Step 1 Log in to the MARS Appliance. For more information, see
page
Step 2 Type pnstop.
Step 3 Press Enter.
Result: The system immediately shows the message:
Please Wait . . .
Followed by the return of the prompt, indicating the command has completed.
To verify the status of the services, enter pnstatus.
Step 4
The superV service does not stop. This service monitors and restarts the other services as needed.

Start Appliance Services via the Console

If the services are stopped, you can manually start all MARS Appliance services from the console. To
list the services and their status, you can use the pnstatus command. For more information, see
Determine the Status of Appliance Services via the Console, page
To start all stopped MARS services, follow these steps:
Log in to the MARS Appliance. For more information, see
Step 1
page
Type pnstart.
Step 2
Press Enter.
Step 3
Result: The system prompt disappears and then returns, indicating the services are restarted.
To verify the status of the services, enter pnstatus.
Step 4
OL-14672-01
STOPPED. The service is not running.
6-4.
6-2.
6-2.
Performing Command Line Administration Tasks
Determine the Status of Appliance Services
Log In to the Appliance via the Console,
6-4.
Log In to the Appliance via the Console,
Install and Setup Guide for Cisco Security MARS
6-5