Cisco MARS Install And Setup Manual page 193

Appendix A Command Reference
Table A-3
Output Field
Status
Note
Size & Block (not displayed for MARS 55)
Model
Serial#
Write Cache (MARS 55 only)
Progress Messages
OL-14672-01
raidstatus CLI command for MARS 55, 110R, 110, 210, GC2R, and GC2 (continued)
Only Online, Failed, Rebuild, and
Undefined are supported on the
MARS 55.
Description
The current state of the physical HDD.
Online—The HDD is functioning normally
•
within the RAID 10 array.
Rebuild—The HDD is being reimaged from
•
its RAID 1 partner to restore full redundancy
to a the virtual disk. The RAID 10 array
efficiency is not yet optimal.
Failed—The HDD originally was Online, but
•
now has an unrecoverable error. An email alert
is sent to the administrator.
• Offline—The HDD was removed by executing
a hotswap remove command, but the HDD
was not physically removed from the slot. An
email alert is sent to the administrator.
Unconfigured Good—The HDD is usable,
•
but the RAID information is out of sync with
the RAID 1 partner. An email alert is sent to
the administrator.
• Unconfigured Bad— The firmware detected a
media error on the hard drive. An online HDD
was probably removed or inserted without
executing a hotswap sequence and the HDD
now has a media error. An alert is sent to
the administrator.
Undefined—(MARS 55 only) A new HDD
•
has been added but is not RAID 1 formatted,
"Undefined" may appear briefly before
"Rebuild."
N/A—There is no HDD in the slot.
•
An email alert is sent to the administrator.
Size of the usable storage on the HDD
The model number of the physical HDD
The serial number of the physical HDD.
The string, "This Drive is Foreign" is appended to
the serial number when an HDD formatted with
metadata from a different RAID controller is
introduced. The message is removed when the
HDD is assimilated into the array.
RAID 1 Write Cache is always enabled.
Install and Setup Guide for Cisco Security MARS
raidstatus (5.x)
A-55