Operation; Positioning The Pendant System; Swiveling The Pendant System; Adjusting The Height Of The Pendant System - Ondal ACROBAT LCH Operating Instructions Manual

5

Operation

Figure 3: Positioning the pendant system
5.1

Positioning the pendant system

(See "Figure 3")
The extension arms 3, the spring arms 4 - 6s and the adaption 7 - 9 with the end
device (e.g. flat screen, OR lamp, etc.) can be positioned easily.
The swivel range and the vertical lift can be restricted through internal end stops.

5.1.1 Swiveling the pendant system

(See "Figure 3")
Damage to the pendant system
To prevent damage to the pendant system:
• Do not hit the end stops hard;
• avoid collisions with other components or systems.
• Slowly swivel the end device (e.g. flat screen, OR lamp, etc.).
➥ The swivel range ends at the internal end stops of the extension arms 3 and the
spring arms 4 - 6.

5.1.2 Adjusting the height of the pendant system

Damage to the pendant system
If the end device (e.g. flat screen, OR lamp, etc.) is moved upwards, there
is a risk that it collides with other components:
• Prior to adjusting the height, check for potential risks of collision.
• Slowly adjust the height of the end device (e.g. flat screen, OR lamp, etc.).
➥ The height adjustment ends at the internal end stops of the spring arms 4 - 6s.
If the components of the pendant system, the spring arms 4 - 6, the adaption 7 - 9
or the end device (e.g. flat screen, OR lamp, etc.) do not remain stable at the set position,
the spring tension must be adjusted as described in
force must be adjusted as described in
77
NOTICE
NOTICE
"Chapter 9.2" on page 95
"Chapter 9.3" on page 97
.
1505093, Edition 2012-05, Version 5
GB
or the brake