Multicast Paging; Network Settings Page Definitions; Ethernet Settings - Grandstream Networks GAC2570 User Manual

• Confirmation Tone
• Call Waiting Tone
Call-Waiting Tone Gain
Default Ring Cadence

Multicast Paging

Multicast Paging
Paging Barge
Paging Priority Active
Multicast Paging Codec
Multicast Listening
•
Priority
•
Listening Address
•
Label

Network Settings Page Definitions

Ethernet Settings

IP Mode
silence. In order to set a continuous ring, OFF should be zero. Otherwise,
it will ring ON ms and a pause of OFF ms and then repeats the pattern.
Please refer to the document below to determine your local call progress
tones: https://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Adjusts the call waiting tone volume. Users can select "Low", "Medium" or
"High".
The default setting is "Low".
Defines the ring cadence for the device. The default setting is
c=2000/4000.
Sets the threshold of paging calls. If the paging call's priority is higher than
the threshold, the existing call will be hold and the paging call will be
answered. Otherwise, the existing call does not be affected. If it is set to
Disable (Default), any paging call will not be answered.
Determines if a new paging call whose priority is higher than the existing
paging call will be answered.
The default is disabled. Check to enabled.
Selects the codec type for the multicast paging call. This list includes
PCMU, PCMA, G726-32, G722, and G729A/B, iLBC, Opus.
Configures the IP address and port number for monitoring multicast paging
call. Reboot the device to make changes take effect.
The valid IP address range is from 224.0.0.0 to 239.255.255.255. Users
may also fill the label for each listening address corresponding to priority.
Selects which Internet protocol to use. When both IPv4 and IPv6 are
enabled, phone attempts to use preferred protocol first and switches to the
other choice if it fails. Available options are:
•
Both, prefer IPv4.
•
Both, prefer IPv6
•
IPv4 Only
GAC2570 User Manual
Version 1.0.1.23
P a g e | 150