Table of Contents
Advertisement
Install the Bracket and Splitter
The body of the splitter may be discolored as a result of the deactivation
process. This is not a defect.
The splitter is usually installed on the right side of the oven.
1 Place the bracket against the side of the oven. The two notches should be up
2 Use two T-shaped thumbscrews to fasten the bracket to the T-slots in the
Figure 7
Use extreme care to prevent any fragments of insulation or other material from
C A U T I O N
entering the makeup gas tubing or the fittings on the splitter assembly. Such materials
could block the internal passages in the splitter or the bore of the capillary restrictors.
Installation and Operation Guide
and the standoffs should face the center of the oven.
oven wall
(Figure
7).
Thumbscrews
Bracket
Detail
Installing the bracket
2
Installation
21
Advertisement
Table of Contents
