Transport And Storage - NetterVibration PKL Series Operating Instructions Manual

Transport and storage

5 Transport and storage
Observe the safety instructions in Ch. Safety, from page 5 on.
Special transport conditions are not required.
Transport
conditions When moving the PKL 10000, use the mounted transport lugs at the top of
the housing.
Packaging The PKL are packed and ready for assembly. Accessories and add-on
parts are delivered unmounted, unless otherwise agreed upon.
The packaging protects the PKL from transport damage. The packaging
material has been selected from an environmentally safe and technically
disposable point of view and is therefore recyclable.
The return of packaging to the material cycle conserves raw materials and
reduces the amount of waste.
Transport
safety device
PKL
1000 /
2100 /
5000 /
10000
* for steel impact plate
The PKL 1000, PKL 2100, PKL 5000 and PKL 10000 are delivered with a
transport safety device at the bottom. The transport safety device consists
of two plastic fastenings (1) and a corrugated cardboard disc (4). It pre-
vents the impact plate (3) from falling out during transport and must be
removed before installation. Take care that the impact plate and damper
ring (flange; 5) retain their position on the PKL, as they must be mounted
with the PKL.
• Store the PKL in a dry and clean environment.
Storage
• Protect the PKL from UV-exposures, weather and ozone.
conditions
• The storage temperature is between -20 °C and +60 °C.
• Close all openings when re-storing.
• Preserve the PKL before storage:
1 Plastic fastening
2 Damper ring (impact plate)*
1. Mount the PKL on a plate. The impact plate of the PKL 1000,
PKL 2100, PKL 5000 and PKL 10000 must be inserted.
2. Apply anti-corrosion oil to the air inlet and briefly activate the PKL.
3 Impact plate
4 Corrugated cardboard disc
5 Damper ring (flange)
11