Safety - NetterVibration PKL Series Operating Instructions Manual

Safety

2 Safety
General areas of application of the PKL are for knocking off adhesive bulk
Intended use
materials from container walls (e.g. silos, hoppers, filter outlets, pipelines
and reactors) and for emptying residues from weighing containers. The
PKL also prevent bridging and rat-holing, so that the material can continu-
ously flow.
The PKL can also be used outdoors as well as in dusty or dump environ-
ments, however not in water or any other liquids.
PKL may only be operated with a timed on/off sequence.
Any other use is considered improper.
Qualification Installation, commissioning, maintenance and troubleshooting of the PKL
of qualified may only be performed by authorised qualified personnel.
personnel
All handling of the PKL is the responsibility of the operator.
Falling parts
WARNING
Falling parts
The PKL, construction parts as well as fastening screws can
come loose due to vibration. Falling parts can lead to severe
personal injuries.
➢ Use only Netter fastening kits (NBS) to fasten the PKL.
➢ The PKL 190, PKL 450 and PKL 740 are open on the
side of impaction. During installation ensure that the im-
pact piston remains in the housing.
➢ Mount the PKL 1000, PKL 2100, PKL 5000 and
PKL 10000 additionally with an impact plate and two
damper rings (flange and impact plate) or with an EE kit
and a damper ring (flange).
➢ Check the fastening screws after one hour of operation
and thereafter at regular intervals (generally monthly).
➢ Retighten the fastening screws, if necessary.
➢ A safety device with a safety cable is mandatory for criti-
cal mounting situations.
5