Removing The Cable; Installing Sun Shade; Installing Corrugated Pipe - Dahua ITC952-AU3F-L User Manual

the screwdriver vertically to loosen and expose the metal sheet of the circular slot.
Step 2 Insert the cable into the circular slot.
Step 3 Remove the screwdriver, and the cable installation is finished.

3.3.2 Removing the Cable

Step 1 Insert the screwdriver into the square slot corresponding to the connecting cable. Press
the screwdriver vertically to loosen and expose the metal sheet of the circular slot.
Step 2 Pull the cable out of the circular slot.
Step 3 Remove the screwdriver, and the cable is disassembled.

3.4 Installing Sun Shade

No.
1, 5
2
3
Step 1 Remove the screws on the top of the camera protective cover.
Step 2 Fix the pillar to the top of the camera protective cover.
Step 3 Align the sunshade with the center hole of the pillar, and securely fix the sunshade with
screws.

3.5 Installing Corrugated Pipe

The corrugated pipe helps protect the cable.
Pull the cable into the corrugated pipe, and then pass the cable through the hole at the bottom of
the Camera. After the cable is properly placed, insert the corrugated pipe into the hole until it is
securely clamped.
Figure 3-6 Cable connection example (2)
Table 3-1 Sunshade connection description
Description
Screw
PTFE gasket
Pillar
16
No. Description
4 Washer
6 Sunshade
7 Camera protective cover
User's Manual