Modifying Ip Addresses In Batches With Configtool; Login - Dahua ITC952-AU3F-L User Manual

Step 8 Select the options according to your needs, and then click OK.
The Initialization page is displayed after initialization is completed. Click the success icon
Step 9
( ) or the failure icon ( ) for the details.
Step 10 Click Finish.
Step 11 The device status on the Modify IP page turns to Initialized.

5.1.3 Modifying IP Addresses in Batches with ConfigTool

You can modify IP address of one or multiple cameras at one time. This section is based on
modifying IP addresses in batches. Modifying IP addresses in batches is available only when the
corresponding devices have the same login password.
Step 1 Do "Step 1" to "Step 3" in "5.1.2 Initializing Cameras in Batches with ConfigTool" to search
for cameras in your network segment.
After clicking Search setting, enter the username and password, and make sure that they
are the same as what you set during initialization; otherwise there will be Wrong
Password notice.
Step 2 Select the cameras which IP addresses need to be modified, and then click Modify IP.
Step 3 On the Modify IP Address page, select Static mode, and then enter start IP, subnet mask,
and gateway. All the IP addresses will be modified sequentially from the start IP.
If DHCP server is available in the network, when you select DHCP, devices will
automatically obtain IP addresses from DHCP server.
Step 4 Click OK.

5.2 Login

Step 1 You can log in to the web by using web browser. For first-time login, see "5.1 Initialization."
Figure 5-9 Modify IP Address
22
User's Manual