Table of Contents
Advertisement
Site preparation
6
Site preparation
6.1
Prepare the site
1. Make sure that the space and the airflow around the cabinet is sufficient. Refer
to section
2. Design the site according to these rules:
a. The length of the DC power cables between the power cabinet and the
b. There is enough space for the EV to reach the CCS connector.
c. Obey the ambient conditions. Refer to section
d. Install sunlight protection at locations, where the power cabinet is exposed
3. Prepare the cables:
•
•
4. Make sure that the cable slack is sufficient to guide the cables in the EVSE. Refer
to section
5. If you use an Ethernet cable, make sure that the internet connection is available
for an approved service engineer and the network operating center of the
manufacturer.
6.2
Control the space and airflow around the EVSE
1. Make sure that the floor spaces meet the requirements. Refer to section
2. Make sure that the air flow inlet and outlet cannot get blocked. Think of snow or
objects.
6.3
Install the cable ducts
1. Install two flexible cable ducts below the power cabinet.
2. Install traction wires in the cable ducts.
38
20.8
.
control box does not exceed the maximum length. Refer to section
Note: It is possible to increase the maximum length of the cables
with a long-distance package. The long-distance package is
included in a separate manual. Ask the manufacturer.
to direct sunlight and high ambient temperatures for most of the day.
AC input cable. Refer to section
Ethernet cable, if no wireless 2G/3G/4G signal is available. Refer to section
20.12.8
. Contact the manufacturer if you require a specific configuration.
1.12
Refer to section
.
Note:
•
The cables enter the cabinet from the bottom.
•
If you install a long-distance package, the procedures about the
Ethernet cables are not valid. Obey the instructions about the
long-distance package included in a separate manual.
20.7
.
20.11
.
20.12.2
.
6AGA000007-0603-EN | 001
20.12.4
.
20.8
.
Advertisement
Table of Contents
