Table of Contents
Advertisement
Mechanical installation of the power supply box
Procedure
1. Align the holes in the brackets (A)
with the holes in the box (B).
2. Install the washers (D) on the bolts
(C).
3. Install the bolts (C) in the holes
from the back of the box.
4. Tighten the bolts to the correct
torque. For the specifciation, refer
to section
10.4
Install the power supply box on the wall
Preliminary requirements
Procedure
1. Hold the box against the wall.
2. Align the holes in the brackets (A),
installed horizontally or vertically,
with the holes in the wall (B).
3. Install the mounting screws (C).
4. Tighten the screws to the correct
torque. For the specification, refer
to section
50
Note: Install all four
brackets either
horizontally or vertically.
20.5
.
1.
The holes in the wall are
prepared. Refer to section
10.2
.
2.
The brackets are installed
on the box. Refer to
section
10.3
.
•
Torque screwdriver
•
Spirit level
20.5
.
B
A
•
Four anchor screws M8x80
A
C
6AGA000007-0611-EN | 001
D C
B
Advertisement
Table of Contents
