Controller Defaults - ABB GPS4827 User Manual

Controller Defaults

Dip Switch Settings
The Millennium has 8 dip switch positions (SW202) that may be changed. SW202 is located on the
MCR1 board, above the MCR2 board. (See figure 4-7)
Switch Position Default
1
SW202-8
SW202-7 0
0
SW202-6
SW202-5
1
SW202-4
1
SW202-3
0
SW202-2
1
1
SW202-1
Page 54
© Copyright 2021 ABB. All rights reserved.
Figure 9-7: Millennium II Controller Dip Switches
Description
Front Panel Configuration
Modem/Aux/Local/Gateway/USB/IRDA
Port Setting Configuration (Remote Access)
Enhanced Security
table 4-H, for features affected
Auxiliary Port Configuration
Remote Rectifier in Standby
Boost Mode
Reserved for Future Use
Reserved for Future Use
Table 9-G: Millennium II Controller Dip Switch Settings
Closed (1)
ENABLED
ENABLED
Mode (See ENABLED
RS-232
ENABLED
ENABLED
ENABLED
ENABLED
Open (0)
DISABLED
DISABLED
DISABLED
RS-485
DISABLED
DISABLED
DISABLED
DISABLED