Millennium Ii Controller Operation - ABB GPS4827 User Manual

9. Millennium II Controller Operation

The Millennium II is factory pre-installed and pre-configured with industry standard defaults for
thresholds and feature operability in GPS cabinet applications. In addition, customer specific default
controller settings may be available upon request. This section provides:
Preparation and Precautions
Procedures for the proper addition of optional packs
Input and output wiring to the controller and the installation and wiring of optional features
Controller default configuration information such as alarm severity and description, system voltage, shunt
information
Controller configuration information
Preparation
The following •
Installation
procedures
•
should be
•
performed
AFTER:
•
But BEFORE:
•
Precautions
•
Observe ESD protection while installing circuit packs.
•
Wear grounded antistatic wrist straps when handling all circuit packs. The wrist strap must contact the skin and is
not to be worn over clothing.
• Never hand a circuit pack from a grounded to a non-grounded person or vice-versa.
Safety
Action
Always consider personal safety before beginning any procedure. Review the Safety section.
Be aware of the presence of unfused battery potential in the vicinity of the controller.
Use only insulated tools.
Make sure the system is properly grounded per the National Electrical Code and local building codes.
Remove all metal jewelry before beginning the installation.
Page 35
© Copyright 2021 ABB. All rights reserved.
All the equipment frames (initial and supplemental bays, free-standing rectifiers, etc.)
are anchored in place.
The battery stands have been erected and the batteries Installed
The overhead cable racks have been installed and the power cables have been run and
terminated.
The plant's charge and discharge bus bar assemblies have been installed.
Connecting the batteries to the plant charge and discharge bus bars or turning up the
plant rectifiers.
Verified