Drying And Lubrication; Necessary Materials - mectron compact piezo LED Use And Maintenance Manual

Hide thumbs Also See for compact piezo LED:

Table of Contents

6.3

Drying and Lubrication

6.3.1

Necessary Materials

• compressed air;

• Soft cloth with low fibre release;

• medical grade lubricant.

thoroughly dry all parts of the scaler

handpiece, scaler nose cone, and light

pipe by blowing them with compressed

air;

CAUTION: the scaler handpiece

electrical contacts must be dry at the

start and end of the sterilisation cycle,

before the cord is connected to the

appliance. Always make sure that the

electrical contacts of the connector

are perfectly dry, if necessary dry them

blowing with compressed air.

CAUTION: Before starting the

sterilization cycle, make sure that

the insert tip is thoroughly dry both

internally and externally. to do this,

blow compressed air both externally and

through the internal passage hole. this

will prevent the appearance of stains,

streaks on the surface or oxidation inside

the insert tip.

CLEANING AND STERILIzATION

NOTE: Adopt a medical-grade lubricant

approved by FDA, for example, the NSK Pana-

Spray or similar.

Table of Contents

Need help?

Do you have a question about the compact piezo LED and is the answer not in the manual?